Specifications

Key to Symbols
1.4 Symbols used on the display
START flashes and reminds to perform the starting
24.40°C
procedure. Select with
the basic menu, then select
rmf;, and press @ ENTER.
ALARM flashes and heater element, pump and if avail-
ALARM
abie, cooling circuit have been switched off. Any cause
of the alarm is displayed in a second line.
FUZZY DENT 43.20%
Lights up if heater is active and flashes during the con-
trol phase.
Lights up if cooling is active with full cooling capacity.
Lights up if cooiing is active with partial cooling
capacity.
Star
1 and 2 are blinking alternately when the cooling
is on.
The crossed out
star is on when the cooling unit is off.
IDENT flashes: After switching on the unit or entering
a new set temperarture, the ~uzzystar~ controller
determines suitable control parameters. It can happen
that heating or cooling is interrupted during this pro-
cess and the displayed temperature changes. This is
because
the controE unit requires some time to deter-
mine the parameters.