User's Manual

KP-7 AlarmForce 2007.3.23
2
z
z
After 5 seconds of key inactivity, the power goes off and it returns to Stand-by mode.
z
z
Upon completion of a command input, the power goes off and KP-7 returns to Stand-by mode.
z
z
T
T
a
a
m
m
p
p
e
e
r
r
P
P
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
:
:
z
z
KP-7 is protected against any attempt to open the lid or to detach KP-7 from its mounting surface.
z
z
In tampered condition, KP-7 will emit a beep every 30 seconds as warning to the user .
z
z
In tampered condition, the Red LED will flash whenever KP-7 is used.
z
z
M
M
o
o
u
u
n
n
t
t
i
i
n
n
g
g
K
K
P
P
-
-
7
7
:
:
z
z
Break through the two or four knockouts where the plastic is thinner
z
z
Using the holes of the base as a template, drill holes in the surface
z
z
Insert the wall plugs if fixing into plaster or brick
z
z
Screw the base to the wall
z
z
Ensure that the tamper switch spring protruding through the back is fully depressed by the mounting surface.
z
z
Fix the lid with the screw and clips to the base
z
z
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
K
K
P
P
-
-
7
7
:
:
1. Remove the cover by loosening the fixing screw
2. Insert three AAA” batteries
3. The Red LED indicator will flash briefly while components initialize and supervision code will be sent out.
z
z
F
F
u
u
n
n
c
c
t
t
i
i
o
o
n
n
s
s
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
:
:
This device complies with Part 15 of the FCC Rules and RSS-210 of Canada. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution :
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
Dual Key Alarm Features:
Arm
¾ PIN code + “ARM
Panic Alarm
¾ 1” + “3” simultaneously
Part Arm
¾ PIN code + “HOME
Fire Alarm
¾ 4” + “6” simultaneously
Disarm
¾ PIN code + “OFF
Emergency Alarm
¾ 7” + “9” simultaneously
Chime
¾
Emergency
¾ +
Status
¾
S