User manual

Part N
umber 6410T0006 Release 10/15/2004 7
I NSTALLATION
RAPID ROLL
®
MODEL 570/670 INSTALLATION
FRAME AND GENERAL INSTALLATION
Step 1. Unpack crate and inventory parts, comparing against the packing list in the front of this manual,
to verify all parts are on site.
Step 2. Using a tape measure, determine the actual door width by measuring the width gauge on the top
roll assembly (Figure 1). Apply this measurement to the actual door opening. Mark the floor on each side
of the opening to indicate the inside position of the side frame assemblies.
FIGURE 1