Troubleshooting guide

SAFETY PRACTICES
WARNING
THOROUGHLY READ THESE SAFETY PRACTICES PRIOR TO
INSTALLING, OPERATING, OR SERVICING A HIGH-SPEED, RAPID
ROLL
®
DOOR. FAILURE TO FOLLOW THESE SAFETY PRACTICES MAY
RESULT IN PROPERTY DAMAGE, PERSONNEL BODILY INJURY, OR
DEATH.
1. Do not operate a Rapid Roll
®
Door while you are under the influence of drugs or
alcohol.
2. Do not use the door if any parts appear to be broken or damaged.
3. Stay clear of the door while it is operating.
4. Keep hands and feet clear of the door at all times.
5. Do not drive through the door opening unless door is completely open.
6. Maintain a clear door opening at all times. Keep the door opening free of any
obstructions.
7. Remove power at the fused disconnect during all electrical or mechanical service.
OSHA requires a disconnect to be properly tagged and locked out during all
maintenance or service of equipment.
8. All electrical troubleshooting or service must be performed by a qualified electrician
or service person and must meet all applicable local, state, federal, and other
governing agency codes.
9. USE EXTREME CAUTION when it is necessary to service the control panel while
it is energized.
WARNING
CONTROL PANEL CONTAINS HIGH VOLTAGE. QUALIFIED ELECTRICAL
PERSONNEL SHOULD PERFORM THE FOLLOWING PROCEDURES ONLY.
WIRING MUST MEET ALL LOCAL, STATE, FEDERAL, INTERNATIONAL, OR
OTHER GOVERNMENT AGENCY CODES. FAILURE TO DO COULD RESULT IN
SERIOUS INJURY OR DEATH.
If you have any questions, please contact your local Albany service provider for
assistance. Otherwise contact Albany Door Systems 1-877-925-2468 for information on
your local distributor.