User`s manual

50
This option determines the manner in which the monitor is goes
blank.
The Choices:
V/H SYNC+Blank (default)
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
Modem Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices: 3 (default), 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWRBTN
Pressing the power button for more than 4 seconds forces the
system to enter the
Soft-Off state when the system has “hung.”
The Choices: Delay 4 Sec, Instant-Off (default).
Wake Up Control
If you highlight the literal “Press Enter” next to the “Wake Up
Control” label and then press the enter key, it will take you a
submenu with the following options:
PWRON After PWR-Fail
This item is used to select the power-on status of your system
after power failure. This field determines the action the system
will automatically take when power is restored to a system that
had lost power previously without any subsequent manual
intervention. There are 3 sources that provide current to the
CMOS area that retains these Power-On instructions; the
motherboard battery (3V), the Power Supply (5VSB), and the