User manual

English 65
Erasing a Stored Frequency
1. Find the frequency you want to erase. Press Hold.
2. Press Func + Pgm.
3. Press 0 and then press E.
4. The displayed frequency changes to all 0s.
Scanning
When you store frequencies into channels, those channels are grouped
into banks. Each bank contains 30 channels. You can store service
channels and non-service channels in the same bank. For example, you
can store a emergency, freenet, marine, etc, together with utilities and
other businesses. There is no frequency range restriction per bank.
While you are scanning frequencies stored in the banks, the word SCAN
scrolls across the display. When it finds a transmission, that frequency
displays.
Enabling/Disabling Channel Banks
You can enable and disable each channel bank. When you disable a
bank, the scanner does not scan any of the 30 channels in that bank.
In Scan modes, press the number key that corresponds to the bank you
want to disable or enable. That bank number displays at (or disappears
from) the top of the screen, showing the currently enabled banks.
The scanner scans all the channels within the displayed banks that are
not locked out. The bank number flashes when the scanner scans a
channel that belongs to that bank.
You can manually select any channel within a bank, even if that bank is
disabled. You cannot, however, disable all banks. One bank must
always be enabled.
Scan the Stored Channels
Press Scan. The scanner scans through all non locked out channels in
enabled banks.(See page 68 for more information on locking out