Instructions

22
English
9. Safety instructions
• Repairs should only be carried out by specialist dealers.
• Do not make any changes to the walkie-talkie.
• Walkie-talkies should not be exposed to excessive heat.
• Do not immerse the device completely in water.
10. Troubleshooting
The device will not switch on or switches off
automatically.
1. Charge the battery.
2. Clean the battery terminals before charging.
I cannot converse with other participants. 1. Make sure you are using the same channel
and subchannel (CTCSS/DCS).
2. You are outside the transmission range of
the other walkie-talkies.
You can hear the other paticipant, but they
cannot hear you.
The participant uses a subchannel
(CTCSS/DCS), but you do not.
Adjust the settings of both walkie-talkies to
match each other.
Other participants only hear you intermittently. 1. The signal is too weak - you are too far
away from one another.
2. Is the external microphone defective?
Please contact a specialist dealer.
I hear wireless messages from other groups. Other users are using the same channel as
you do - switch the channel.
11. Electronic waste law and recycling
European laws prohibit the disposal of defective or unusable devices in the household
waste. If you want to dispose of your device, make sure you hand it over to one of the
municipal collection points for recycling. These collection points are nanced by industry
and ensure the environmentally sound disposal and recycling of valuable raw materials.
12. Declaration of conformity
Alan Electronics GmbH hereby declares that the Tectalk Worker 2 walkie-talkie
complies with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following Internet address:
http://service.alan-electronics.de/CE-Papiere/