Owner`s manual

11
CH -- the digits that precede this indicator (1-500) show which channel the scanner is
tuned to.
AM/WFM -- appears when the scanner scans a frequency set to the AM, FM, or
WFM mode, or flashes when you change a frequency to the AM, FM, or WFM mode.
ATT -- appears when you turn on the scanner's attenuate feature.
SIGNAL -- shows the receiving frequency's signal level with 8 dot.
FUNC -- appears when you press FUNC key and use secondary function key.
Display Message
Error -- appears when you make an entry error.
-dUPL- -- (duplicate) appears when you try to store a frequency that is already stored
in another channel.
CH-FULL -- appears when the all channel memories are entered while searching.
L-FULL -- appears when you press L/OUT key while the scanner lockout 200
frequencies in search mode.
A-FULL -- appears when you select a full bank while auto programming. Or appears
when you finish sorting a full bank.
AC-XX CH -- appears with a number to show the number of empty channels in a
bank.
Sor. -- appears when the scanner sorts frequencies. See "Sorting Frequencies Within
A Bank" on Page 23.
Pri-On -- appears when you press PRI key.
PCH ALL-OFF -- appears when you press PRI key while scanner's all priority
channels are empty or locked-out.
rEcord -- appears when the scanner receives signal and record the transmission with
tape recorder by tape recorder remort control function (see “Tape Recorder Remote
Control” on Page 28).