User manual

6
Re- Programming to another
country code
This is possible at any time,
even after installation and
when the radio is in use. The
procedure is the same like
Your first setting.
Installation of the radio
You can either operate Your ALBRECHT AE 5090 XL in the car or at home as a base
station. For installation as a mobile station in the car, a mobile mount device is
enclosed. Mount the set in such a way that it is not exposed to direct sunlight if
possible, as this would lead to an increase in the temperature and can decrease the
(set’s) working life. The set should also not be installed near a heater. Mount the set
in such a way that it is exposed to as little vibration as possible.
The mobile fixing device should be attached to the dashboard, the tunnel slot or to
any other suitable place using the enclosed tapping screws. Do not install the set in a
place where it could cause injuries in the case of an accident (be particularly careful
to ensure free leg movement). Take care not to damage any underlying wires during
installation!
Then insert the radio into the mobile mount. Secure the set with the large knurled
screws (using the enclosed plastic washers) firmly at the required angle.
Also mount the microphone hanger using the enclosed screws in an easily accessible
place. If a safe mounting of the radio is not possible in Your car or truck with the
supplied mounting bracket, we recommend to use one of our DIN slot mounting kits
suitable for AE 5090 series! Such mounting kits for a free DIN slots are available as
optional accessory items.
In order to prevent interference to the vehicle electronics from transmission in the
vehicle, please make sure to take any mounting instructions from the vehicle
manufacturer for radios and antennas into account.
Power supply
Your AE 5090 XL receives power from the 2 pin plug-in cable.
The red and black wires in the cable are for the power supply. The cable has a
looped-in fuse.
However, You can choose from two methods when connecting to the power supply
(red and black):
Example 1
The Radio should be able to be switched on and off at any time using the
volume / on/off switch.
Connect up the red wire to the positive pole on the vehicle battery (or
elsewhere in the vehicle’s electrical system with permanent plus) or to a 12
Volt external power supply unit.
Mode Channel Power Modulation
01 80 CH 4W/1W FM/AM
02 40/40 4W/1W FM/AM
03 40 4W FM only
04 40/40 4W/4W FM/AM (only Spain)
05 40/40 4W/4W FM/AM (only Poland)
with 0 kHz offset
(Poland Frequencies