User manual

11
The Setup Menu
Some more, not frequently used functions are available via selectable Setup Menu steps. You start the
setup menu by longer pressing (longer than 0.5 sec) of the function key FUNC.
Flow-chart for the Setup Menu
• Within a menu step you can select the values or actions by UP- or DOWN-keys, the rotary
switch or as far as DTMF tones and repeater shift values are concerned, by keyboard.
• The next menu step can be reached by subsequently pressing the FUNC key.
• After the last menu step the first step will start again.
• Quit the Setup Menu by pressing the PTT-key shortly.
More about the menu steps
T-SQ : Selection of CTCSS (continuos tone coded squelch system) frequencies is possible
between 67.0 and 250.3 Hz. You may use the rotary switch or up down keys for
selection. The 38 different tone frequency follow international standards and are used by
most manufactures (compatible between the brands). You will need an optional CTCSS
module (sold separately). The CTCSS unit can be installed by plug-in after opening the
upper cabinet (no soldering or adjustment required). CTCSS is used to create closed
user groups in a radio network, where all transmitting stations transmit the same low
audio signal frequency parallel to microphone modulation. This is called encoder
function, where the display shows T only. The receiving party can decide whether they
want to listen to all radio traffic or only to radio traffic of the same user group. In that
case the decoder will be activated. Speaker will be on only if the received signal carries
FUNC key (press
min. 0.5 s)
SET MODE FUNC key (press min
0.5 s )
STANDARD MODE
Transmit key (PTT)
T-SQ
MEMORY
DTMF
dA ON/OFF
dt (DTMF)
ON/OFF
+,- SHIFT
bP (BEEP)
ON/OFF
rb (Roger)
ON/OFF
StEP
toT
These menu steps appear
only if the corresponding
module(s) (CTCSS and / or
DTMF) are installed.