Specifications

24
• To change a search range, press Func and PSrc. In the
display SRCH appears.
• Then select a search bank. When you select the search
bank, the lower limit and upper limit frequency assigned
in the search bank alternate on the display.
• To select another search bank, press Func + PSrc or
Func +
to increase the search bank number or Func
+
to decrease it.
• Hold down Func +
or Func + for about 1 second
to quickly move through the search bank numbers.
After choosing the search bank, follow these steps to set the
lower limit and upper limit frequency.
• Enter the lower limit frequency by using the 0-9 and ●
/Clr keys.
• Press E to select the lower limit frequency.
• Enter the upper limit frequency by using the 0-9 and ●
/Clr keys.
• Press E to select the upper limit frequency.
Direct Entry Search
You can use direct entry search to search up or down from the
currently displayed frequency.
• If the scanner is scanning or searching, press Hold.
• Enter the frequency you want to start from by using the
number keys 0-9. (Use ●/Clr to enter a decimal point).
• Press Func +
or Func + . The scanner searches,
starting from the frequency you entered in the step
before.
• If you enter a frequency that is out of range, the scanner
sounds an error tone and Error appears.
• Press Func +
to change the search direction
downward or Func +
to change the search direction
upward. Frequencies appear during the search.
Notes:
• You can set the delay function on or off during the search
or while the search stops.
• You can skip a frequency when the search stops. After
the search skip frequency is set, the scanner starts direct
search again.
Direct Entry Search Hold Mode
• To stop searching during direct entry search, press Hold.
Hold appears.