User manual

Front panel Key Functions
General description of the key functions:
• All functions printed directly on the buttons can be reached directly by pressing the button
• Functions which are printed above or below a button are secondary functions and can be
reached by pressing the F (function) button on the left side first and then the button near
to the printing.
Key
Function
LED is green when a receiving signal opens squelch
(UP) Increase the channel number, frequency, volume or squelch,
frequency, or change the search direction upwards.
(DOWN) Decrease the channel number, frequency, volume or squelch,
frequency, or change the search direction downwards.
Band selects one of the max. 5 pre programmed bands of the scanner
F + B.Set can be used to disable or enable one or more of the max. 5
bands, for example if not all bands need to be used.
VOL switches the UP/DN keys to be used as volume higher / lower
SQ switches the UP/DN keys to be used as squelch more close / more open
CURSOR can be used to change the decimal point during frequency search
to obtain larger steps.
F + Delay can be used to insert a delay time between signal disappears and
scan restarts again
F + Save Store a frequency in one of the 199 channel + 5 priority channel
memory locations
RECALL Recall stored frequencies in memorized address locations
F (press 3 seconds) + REGION selects between European standard
programming and the German pre programmed search bands and reverse.
Start-Stop is used to start or stop scanning or frequency search process
LED
Busy Display