User manual

Key Function – short description
F + Pri selects priority channels (if programmed)
SKIP: If you do not want the scanner to stop at the displayed frequency or
channel, press SKIP to lock-out (mark) the frequency. During next scan or
search process the scanner will not stop there.
F + Step selects the channel spacing in the present band. In some pre-
programmed German bands, the channel steps used there are fixed and
cannot be changed. In the European setting, all possible channel steps can
be selected.
Lamp: switches the background illumination on
F + FM/AM selects between FM and AM mode, where necessary (for
example in the CB band. In some bands (air band or VHF high band) the
modulation is fixed to the system which is in use there and cannot be
selected.
BEEP allows keyboard click sounds or disables them
Operation – in details
Power on and off
Make sure the scanner's antenna is connected before your turn it on.
• Press and hold PWR button on Top panel for 2 seconds. The scanner will turn on after a
short internal test and a start melody can be heard.
• The scanner memorizes the last band and other settings which had been in use before.
A new scanner will start with the factory default Air Band setting.
A limited frequency range will appear in the display.
The Scanner will automatically start “scanning” (this means an automatically frequency scan will
start to discover used frequencies within this range).
Adjusting the volume level
Press the combined VOL-SQ button once. Now you have 10 seconds time to select
the desired speaker volume by means of the UP-DOWN keys.
You can see in the display the bar graph in the lowest line showing the selected
volume steps: