User manual

Normal Search Mode
So you first search, find frequencies, put them into memory locations and later you recall or
scan the memorized “channels”
means: starting and stopping the search process at any time manually.
Starting Frequency Search
If the squelch is adjusted correctly, the radio will also stop automatically as soon as it finds a station
talking on the just checked frequency.
If the squelch is open, then each pressing on
will only add one frequency step to the
frequency displayed before.
You can now decide to
• Restart the scanner, if the communication is not interesting
• Stop the scanner, note the frequency on paper for later use or save the frequency into a
memory location
• Wait until the signal disappears and then let the scanner automatically resume
In this last case it may be important to know the DELAY function.
Delay selection
If one partner stops the conversation, then in most cases it will take a small moment until other
partner station continue the communication.
If you would not consider any delay in scanning restart, the scanner would start immediately and
would not find the answering stations. So it is usually necessary to allow the scanner a delay of
some seconds before it resumes searching or scanning again.
You can program 0 ( this means delay off) to 5 seconds as delay, before the receiver starts again.
• Press F + DELAY
• Press UP or DOWN to change the delay time
Storing a Frequency into a memory location
At any stopped frequency it is possible to save this frequency into one of the memory locations.
Just press
F + to save the
frequency.
The frequency display and a free location number
will blink subsequently
F
blinking frequency and memory location