Specifications

for VHF High band bank. Or, it is also possible to program

200 channels for only Air band.

Operation – in Details

Turning On The Scanner and Setting Squelch

Note: Make sure the scanner's antenna is connected before

you turn it on.

• Press and hold PWR for 2 seconds. The scanner

turns On.

• Press VOL/SQ. SQ appears with the current

• setting.

• Repeatedly press or to select the squelch

level you want.

• Squelch is fully open at level 0, and most tight at

level 10.

Note: Squelch can be adjusted both in Frequency

Mode and Memory Mode.

Adjusting the Volume Level

• Repeatedly press VOL/SQ until VOL appears.

• Use

or to select the volume level you prefer

from 30 levels.

• Press PWR or wait for 2 seconds to return to the

mode you were in.

Note: Volume level can be adjusted both in Frequency

Mode and in Memory Mode.

Frequency Search Mode

Changing the Frequency Steps

You can change the steps of each band.

• Press FNC + STEP until a band you want to change

appears.

• Use

or to select steps from Auto, 5kHz,

6.25kHz, 8.33kHz, 10kHz, 12.5kHz, 15kHz, 20kHz,

25kHz, 50kHz and 100kHz.

• Press PWR or wait for 2 seconds to return to the

mode you were in.

You can search for Air, FM Radio and VHF High band

without knowing the specific frequencies used in your area.

Press

or to change the search direction.

When the scanner stops on a transmission, press