Specifications

18
RSM/HOLD to stop searching and listen to the transmission.
HOLD appears. In this mode, you can press
or to
increment or decrement the frequency by 1 step. Press and
hold
or to increment or decrement frequency
continuously.
• To release the hold and continue searching, press
RSM/HOLD.
Registering a Found Frequency in Memory
You can store frequencies you found during Frequency
Search Mode or Frequency Hold Mode into channels.
• Press FNC + MW. A blank channel and the
frequency you found are displayed alternately.
• Repeatedly press
or to select the channel
where you wants to register.
• Press FNC + MW to complete the registration.
• Registered channel frequency is distributed to each
bank according to the a frequency band.
If you entered a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was duplicated.
If you entered the frequency by mistake, press PWR
then enter the correct frequency. To enter the
frequency anyway, press FNC + MW to accept.
Editing and Erasing a Frequency
Follow the steps to edit the frequency.
1. Press FNC + MW for two seconds.
2. Repeatedly press
or to move the cursor to
the digit you want to edit.
3. Repeatedly press FNC +
or to change the
number.
4. To register the frequency, press FNC + MW.
To move to frequency mode to start searching
from the frequency, press RSM/HOLD.
To erase the frequency, press L/O at step 2 and FNC + WM
to confirm. The channel is automatically locked out.
Scanning the Stored Channels
(Memory Scan)
• To begin scanning channels, press RSM/HOLD. The
scanner scans through all non-locked channels in the
Channel Memory.
You can choose band during scanning from Air, FM Radio
and VHF High.