Operation Manual

20
OPERATION
SELECT STEP FREQUENCY
You can change the steps of VHF-Low, FM, Aircraft, VHF-High and UHF
bank.
1. Press
(Srvc)
until a bank you want to change appears.
2. Press
(Stp)
until a step mode appears.
3. Use the ▲/▼ to select steps from Auto / 5.0 / 6.25 / 10.0 / 12.5
kHz (The Step for Aircraft bank is 8.33 or 12.5 kHz.)
4. Press
(Clr)
or
(Stp)
or wait for 2 seconds to return to the mode
you were in.
LOCKOUT PREPROGRAMMED FREQUENCY
You can skip up to 40 specified frequencies during a Service scan. This lets
you avoid unwanted frequencies in Service Scan Mode.
To skip a frequency
•
Press
(L/O)
when the scanner stops on the frequency in Service
Scan Mode or when you have selected frequency manually in
Service scan hold mode.
L/O
appears.
To cancel skip for a single frequency
•
Manually select the frequency, then
(L/O)
.
L/O
disappears.
To cancel all skip frequencies
•
Press
(Hold)
to stop scanning in Service scan hold mode, then
press & hold
(L/O)
. A confirmation tone sounds.
LOCKOUT FAVOURITE CHANNEL
You can increase the scanning speed by locking out channels that you do
not like or which have a continuous transmission for all the channels in
favourite channel memory.
To lock out a channel
•
Manually select the channel, then press
(L/O)
.
L/O
appears.
Note:
You can still manually select locked-out channels.
To remove the lockout from a channel
•
Manually select the channel, then press
(L/O)
.
L/O
disappears.