User manual

of your audio-gateway. Plug the wall charger in a 230V socket.
• Insert the Bluetooth™ headset in the audio gate way as shown below. The charging light at the
audio gateway will light up.
• Lift up your telephone handset. You should hear the normal dial tone and be able to use your
telephone (with the original handset) as usual. In case you don´t hear anything, check the newly
plugged-in connections and check out the other positions of the slide switch at the bottom of the
audio gateway. One of the 8 positions will give you your desired signal. Leave the switch in this
position. The switch is needed to cover the variety of wirings of wired telephones of the different
brands. In most cases the preselected position (1) will be the right one.
Charging the BT 2000 in the charging cradle of the audio gateway
Charging starts the moment the headset is being inserted in the audio gateway. It takes approx. 1.5 to 2.5
hours to fully charge a completely empty BT 2000. The left indicator light gives you information of the state
of charging. (Orange = charging, green = battery full). A red light indicates either a defect of the battery or
that the headset is not in the correct position in the audio gateway.
• You can reduce the charging time by switching off the Bluetooth™ headset before charging (in
direction of the arrow).
handset connection