Operation Manual

PTT or MODE button or wait for 5 seconds to store your

choice.

• Switch on the unit whose settings are to be changed (the slave

unit). Press the MODE button until 'CL' appears. Use the UP or

DOWN buttons and select 'IN'. Press the PTT or MODE button or

wait for 5 seconds to store your choice. The radios LED will turn

green to indicate that it is ready to receive data.

• Press the PTT button of the master radio while the slave radio LED

is green. The LED of the slave radio will go off. The master radio

and slave radio will emit a confirmation beep.

• If the cloning procedure should fail, the slave radio sends an error

beep and the LED remains green. Repeat step 4 until a

confirmation beep is heard. If repeated cloning attempts should fail,

repeat the whole procedure from step 1.

If the cloning procedure was successful switch off both radios and

disconnect the cloning cable. Switch on the slave radio to use the copied

data.

Squelch Level Adjustment

This function allows you to adjust the squelch level of your radio. To change

the squelch level, press the Squelch/Mon button briefly. The current

squelch setting will flash. Use the UP or DOWN button to change the

setting. Press PTT or wait for 5 seconds to store your choice.

There are 15 squelch levels. Level 1 is the most sensitive (open) and level

15 is the least sensitive (closed). Auto is the optimum factory setting and 'Off'

is fully open, with constant static noise.