Use and Care Manual

40402 & 40403 Assembly Instructions
Page 3
CABINET OPERATION
1. Assemble light and siphon gun/foot pedal per instructions.
2. Attach gloves to inner glove hole collar and secure with glove
clamps included in parts kit.
3. Remove dust collector hose from bottom of drum and connect
one end to the dust collector and the other end to the right upper
side of cabinet.
4. Plug light and dust collector electric cords into your 110 volt, 60
cycle electric line.
5. Pour 25 – 50 pounds of dry abrasive blasting material into cabinet
through door opening.
6. Attach air line to air inlet (if you have a trigger gun) or foot pedal
valve marked “IN” (if you have the foot pedal option).
7. Most blasting operations will be performed between 60 and 100
PSI. Regulate pressure at compressor as necessary. Maximum
110 PSI.
WARNING AND SAFETY INFORMATION
Do not operate cabinet or air flow with cabinet door
open or with cabinet lens removed.
Do not use fluids or mix fluids with blast media.
This cabinet is designed for dry blasting only.
Do not exceed maximum operating pressure of 110 PSI.
WARNING!
Disconnecting hose while Unit is under pressure could cause serious injury or death. Use
safety lock pins and safety cables in all coupling connections to help prevent hose couplings
from accidental disconnection.