Use and Care Manual

— 9 —— 8 —
INSTALLATION
Installing the Camera
w
Connect the small end of the AC adapter
to the camera’s DC IN Jack.
x
Insert an SD Card (up to 32GB-Not
included) into the SD Card Slot. This
will allow you to record videos.
y
Plug the other end of the adapter to a
120 volt AC (standard indoor) power
outlet. After 30-60 seconds, the red
Power Status LED will repeatedly blink
three times rapidly.
The camera is now ready to be set up on
an Android or Apple device as shown in
pages 11 or 14.
Back of the card
TIP: A 6 foot power extension cable is included for
your camera setup if needed.