Use and Care Manual

— 40 —
REMOTE ACCESS
Advanced Settings
NOTIFY ENABLE (Apple only): Tap to turn this
option on and you will be notified when motion
has been detected.
SENSITIVITY SETTINGS: Tap Detect Mode to
set the desired Sensitivity Settings as follows:
Off: Turns sensitivity off.
Software: Uses advanced software along
with the Passive Infrared Sensor to achieve
optimal motion sensitivity.
When set to software, you can then set the
Motion Detection sliders for Day and Night.
EMAIL SETTING (Only used with Gmail
accounts): Tap to set your Gmail account in order
to receive email alerts. Fill in the following fields:
USE SSL: Tap the SSL switch to transmit
the data with encryption. This setting requires
the Simple Mail Transfer Protocol (SMTP)
configuration. Most ISPs use the SMTP method
to transfer outbound mail via the internet. Only
use the SMTP that supports SSL.
SMTP SERVER: This should be smtp.gmail.com.
SMTP PORT: Enter 465.
USERNAME: Enter your Gmail username.
PASSWORD: Enter your Gmail password.
RECEIVER: Enter the email address you want the alerts to go to. (This can be different
than the SMTP outgoing email account.)
Tap the check-mark when done.
SD CARD FORMAT: Tap and then confirm to format the microSD card inserted in the camera.
OVERWRITE SD CARD: Tap this switch to activate. When activated, the camera will delete
the oldest recordings in order to record new files when the MicroSD card is full.
DEVICE PROFILE SETTING - LOAD: Tap to load in a previously saved Profile (Time Zone,
Video Setting, Sensitivity, Email and Overwrite). This is useful if you want to apply the same
settings to another camera quickly.
DEVICE PROFILE SETTING - SAVE: Tap to save the current Advanced Settings (Time Zone,
Video Setting, Sensitivity, Email and Overwrite).
DEVICE INFORMATION: Tap to view the device information, including current firmware
version, total size and free size (space available).