User's Manual

76/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
104
Figure 42 – Positioning the management bar
11. Prepare the conductors for insertion into the RJ45 plug.
1. Trim all the conductors so that they extend from the management bar by 6 mm (0.25 in.); see
Figure 42.
2. Pull the management bar to the ends of the conductors, as shown in Figure 43.
Figure 43 – Preparing the conductors for insertion into the RJ45 connector
12. Insert the management bar (with conductors and ferrule) into the RJ45 plug; see Figure 44. When
the management bar stops, continue to push the conductors until they can be seen under the plug
contacts. Inspect the conductors by looking through the transparent plug to ensure that all
conductors are pushed completely under the contacts, and are ready for termination.
Warning - The cable may not function properly if all conductors are not positioned correctly.
4 mm
(0.15 in.)
6 mm
(0.25 in.)