User's Manual

3CC12426AAAA TQ BJA 01 Issue 01 - April 2001 - Draft 04 181/346
234
4.9.3 – Network addresses
Note: In order to allow modifications in this Network address screen the "Remote Interface Mode" box
of the IP addresses screen (see § 4.9.2 – IP addresses) must not be selected.
To access the settings for configuring the interfaces, click on the button in the
BS Details screen toolbar, shown here.
This involves informing the system of the interfaces used by the managers.
The manager is the network supervision software (7390 LT or NSM).
FOR REMOTE LT: INTERFACE ROUTE MUST BE DEFINED IN "IP ADDRESS" DIALOG
BOX (§ 4.9.2 –) BEFORE ENTERING THE MANAGER IP ADDRESS INSIDE THE
"NETWORK ADDRESS" WINDOW
Click here if the system is in WAN network type to
lock the IP address modification
Click here to enter the 4 bytes of the BS interface
IP mask at the Ethernet Interface
Click here to enter the 4 bytes of the IP address of
the router of the BS at the Ethernet Interface
Click here to enter the 4 bytes of the IP
address of the BS at the Ethernet Interface
Both addresses together define the subnetwork the
manager connected to route 1 belongs to
Target Network
mask used on route
IP address of manager
connected to route 1
Click here to scroll down the list and select the
type of interface used on the BS to connect
the local manager (ETH) (no by default)
Click here to scroll down the list and select the
type of interface used on the BS to connect
the remote manager (ATM)
IP address of manager
connected to route 2
Target Net w o r k ma s k
used on route 2