User's Manual

196/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
234
4.12.1.4– Ports configuration of TNT board (BS)
The screen listing the E1 ports of the TNT is displayed:
Note: The modification of the port configuration is possible if the port state is locked.
Note: Unlocking a TNT port state is only possible when you have configured it.
Next
, access the ports configuration of the TNT board selected by clicking on the first
button, shown here (on the toolbar of the E1 cross-connections screen).
On the E1 cross-connection screen (see § 4.12.1.3 –
Presentation of the E1 link management screen ), select first of
all, the TNT board concerned by the cross-connect by scrolling
The port labels are to be
entered in the TNT Ports
Configuration screen:
(cf: § 4.5.3.2 –)
Port type: G703, G704
(initially E1)
Type of line code: hdb3
(one choice)
Check box to lock / unlock the port’s
administrative state. By default, the port is locked.
Port configuration modification is only possible
when the port is locked
Scroll down the list to configure
the port: structure or unstructured
(initially: not configured)
Appears if the configuration state is
structured; to be checked if the
corresponding hardware uses CR4