User's Manual

228/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
234
4.14.3.1– Downloading steps
– pre-requirement: AMD boards should be configured (mandatory).
There are two possible cases in point, influencing how the downloading steps should proceed: i.e.,
whether or not the MIB versions (databases modelling the equipment) are different for the mana-
ger and for the agent. Once downloading is run, the system detects automatically any discrepancy
between the MIB versions, and realigns where necessary.
Note: The About 7390 LT window gives the database version (see § 4.2.2 – Accessing and running
7390 LT).
The downloading steps are as follows:
1. Select the file describing the software configuration (action in Software Management screen)
(§ 4.14.3.2 – Object and destination of the software to be imported),
2. Select the software storage zone on the BS (action in Software Management screen) (package 1
or 2),
3. Load the software (action in Software Management screen) (§ 4.14.3.4 – Software import),
4. Rendering MIB compatibility: (in the case of divergent MIBs) (automatic in other screen)
( § 4.14.3.6 – Rendering compatible the MIBs),
5. Referencing of the software (action in Software Management screen) (§ 4.14.3.7 – Referencing
software),
6. Activate the selected software configuration (action in Software Management screen) (§ 4.14.3.8 –
Activation of data),
7. Updating the statuses on the 7390 LT: wait for 10 minutes approximately (action in Software
Management screen, § 4.14.3 –),
8. Start again Loading the same package on the other software storage zone (without activating nor
referencing it) to enable automatic update of the new NTs coming in the network.
Note: Each software package must be individually exported via NFS Server (see A.2.6.2 – Installation
of NFS server)
• NR 2.1 to NR 2.2a upgrade is described in § 7.3.12.2 – Upgrading the equipment from release
2.1 / 2.2a to 2.2b
• Commissioning for the first time is described in § 7.3.13 – First 7390NE software update
• NR 2.1 to NR 2.2b upgrade is described in § 7.3.12.2 –Upgrading the equipment from release
2.1 / 2.2a to 2.2b
• NR 2.2a to NR 2.2b upgrade is described in § XXXXXXXXx
4.14.3.2– Object and destination of the software to be imported
To select the software to be downloaded, click on the button shown here (see screen
§ 4.14.3 – Downloading); the updated list of software is displayed; double click on the
file to be imported, on the «Apply» button then on «Close».