User's Manual

3CC12426AAAA TQ BJA 01 Issue 01 - April 2001 - Draft 04 233/346
234
4.14.3.7– Referencing software
The committed software is activated by default when restarted; for the referencing of the software:
Note: This button is activated if the software status is "enabled".
4.14.3.8– Activation of data
To run the downloaded software:
Note: Once the MIBs have been rendered compatible, the equipment (NE) reboots with the new IM
version.
The link with the LT is broken. Reconnection to the NE and recovery of the data therefore requi-
res a new version of the corresponding LT. For this, refer to the procedure described in A.2.2 –
Installation Procedure CHANGING THE DESTINATION DIRECTORY of the program ("Change
directory" button), so as not to overwrite the old version of the 7390 LT.
Note: Once the software is activated and referenced, do not forget to start again downloading the same
software on the other software storage zone (without activating or referencing it) to re-create the
NFS assembly point, so as the new NTs that come in the network can perform automatic down-
load.
Select first of all
the required storage zone,
then,
click on the «Referencing» button of the Software Management screen button
bar shown here.
The "Committed" zone of the Software Management screen (§ 4.14.3 –
Downloading) is automatically filled.
Click on the «Activate» button of the Software Management screen button bar
shown here.
The "Activated" zone of the Software Management screen (§ 4.14.3 –
Downloading) is automatically filled.