User's Manual

244/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
278
– Start NT supervision (see § 6.2.23 – Start NT Supervision)
– Stop BS supervision (see § 6.2.24 – Stop BS Supervision)
– Start BS supervision (see § 6.2.25 – Start BS Supervision)
– Backup (see § 6.2.26 – Backup),
– Restore (see § 6.2.27 – Restore).
Note: The operator is advised of any inappropriate commands by error messages (see Appendix 6 –
Error messages and corrective actions).
6.2.1 – Time setting
6.2.1.1 – Manual time setting
Time setting is carried out from the BS Details screen (see § 4.5 Base Station Supervision) by clicking
on the «Set Agent time» button (see § 4.5.5 Sending time to the Agent). The system updates its time
only when manual time setting is done.
Note: Manual time setting is not allowed when SNTP server is configured.
6.2.1.2 – Automatic Time Setting by SNTP
Note: Once the automatic time setting is set, the system updates its time every fifteen minutes with the
SNTP server time.
6.2.2 – Configuration of frequencies and transmit power
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Configuration of
the IP address of
SNTP server.
Go to the Time Management screen and configure
an IP address time server.
4.14.4
II Check that SNTP
server is available.
Check that the time server loss alarm has
disappeared.
4.10.1.3
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Access to the
Radio Configura-
tion screen.
Go to the Radio Configuration screen from the
BS Details screen.
4.5
II Definition of the
radio parameters.
In the Radio Configuration screen:
- select the radio link tab,
- define the channelization type
- define the frequency of the uplink channel,
- define the frequency of the downlink channel,
- define the transmission power (dBm)
- validate.
4.7