User's Manual

3CC12426AAAA TQ BJA 01 Issue 01 - April 2001 - Draft 04 247/346
278
6.2.7 – Configuration of IP addresses
IP configuration consists in defining:
– the IP addresses of the BS, corresponding to each of the ATM and Ethernet interfaces,
– the sub-nets of 7390 LT managers associated with the ATM and / or Ethernet interfaces.
6.2.7.1 – IP addresses of the ATM and Ethernet interfaces of the BS
Note: IP address 0.0.0.0. is not rejected but the system remains with the former IP address.
BOTH IP ADDRESSES MUST BELONG TO DIFFERENT SUB-NETS.
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Access to the IP
address parame-
ters of the BS.
Go to BS’s Local Networks screen from the
«Change IP address» button.
4.5
4.9.2
II Allocation of an IP
address to the ATM
interface.
In the "ATM Network" part of the BS’s Local
Networks screen:
- enter the Pvi/Vci parameters,
- select the bit rate,
- validate.
Nota:This stage can be not performed. In this case
the IP interface remains not configured.
4.9.2
III Allocation of an IP
address to the
Ethernet port.
In the "Ethernet Network" part of the BS’s Local
Networks screen:
.- define the IP address,
- define the sub-net mask,
- enter the IP address of the router associated with
the Ethernet input,
- validate.
Nota:This stage can be not performed. In this case
the IP interface is configured with default IP
address of the BS (192 168 99.1).
4.9.2
IT IS RECOMMENDED TO CHANGE THE ADDRESSES OF THE BS WITH A LT
CONNECTED LOCALLY TO THE BS.