User's Manual

248/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
278
6.2.7.2 – Sub-net of Manager (7390 LT)
Note: The two sub-nets can be associated with the same interface.
6.2.8 – Configuration of the NFS Server
In order to keep a connection between a DBS and a NFS server (even after a DBS reset), it is possible
to configure the access to a NFS server. Once done, any board or NT with a wrong software version will
be automatically updated..
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Access to "Network
address" settings
Go to the Target Network screen from the
«Change Network address» button.
4.5
4.9.3
II Definition of the
manager sub-net
associated with
interface 1.
In the "Interface 1" part:
- define the IP address,
- define the sub-net mask,
- define the interface associated with manager 1
(ATM or Ethernet),
- validate.
4.9.3
III Definition of the
manager sub-net
associated with
interface 2.
In the "Interface 2" part:
- define the IP address,
- define the sub-net mask,
- define the interface associated with manager 2
(ATM or Ethernet),
- validate.
4.9.3
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Selection of a File
Server Type.
Go to the NFS Server screen:
- select the File Server Type.
In case of 7390 LT Server, perform step II.
In case of External Server, perform step III.
4.14.1
II Selection of the file
which describes
the software confi-
guration (7390 LT
server).
In the NFS Server screen:
- click on the «Browse...» button,
- select the File descriptor in the File Browser
screen,
- click on the «Apply» button,
- then, close the File Browser screen.
Nota: In the NFS Server screen, Package Location
and File descriptor parameters are automatically
updated.
Do not perform step III and go to step IV.
4.14.1