User's Manual

3CC12426AAAA TQ BJA 01 Issue 01 - April 2001 - Draft 04 251/346
278
6.2.13– Change of alarm severity profile
6.2.14– Service creation leased lines, IP, CES, ISDN
Several cases may be distinguished according to whether leased lines (E1, X21, T1, CES) or IP cross-
connect creation is involved.
6.2.14.1– Creating an E1 cross-connection
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Select the ASAP - Go to the ASAP List screen, select the ASAP.
- Click on «Modifiy ASAP» button.
4.10.2
II Change severity of
a label.
- Click on the severity to be changed to make
appear scroll down list.
- Select the new severity. Repeat this action for
the severities to be changed.
- Finally, validate by clicking on «Apply».
4.10.2.2
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Configuration of
TNT port on BS
Go to the E1 cross-connections screen:
- select the TNT board,
- access the configuration of the TNT board ports,
- select a port from the list,
- configure the port:
.
select structured or unstructured,
.
validate by clicking on «Apply».
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
4.12.1.2
4.12.1.3
4.12.1.4
II Configuration of
port on NT
Go to the E1 cross-connections screen:
- select the NT,
- access the configuration of the NT ports,
.
select structured or unstructured,
.
validate by clicking on «Apply».
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
4.12.1.3
4.12.1.5
III Cross-connection
of timeslots of
selected ports
In the E1 cross-connections screen:
- two cross-connect modes are available
depending on whether the cross-connection ports
are structured or unstructured.
- validate the cross-connection by creating the E1
cross-connection (following step).
4.12.1.6