User's Manual

3CC12426AAAA TQ BJA 01 Issue 01 - April 2001 - Draft 04 253/346
278
6.2.14.3– Creating a T1 cross-connection
V Unlocking and
activating the
cross-connection
In the E1 cross-connections screen:
- click on the «unlock» button.
4.12.5.5
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Configuration of
TNT port on BS
Go to the T1 cross-connections screen:
- select the TNT board,
- access the configuration of the TNT board ports,
- select a port from the list,
- configure the port:
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
4.12.3.3
4.12.3.4
II Configuration of
port on NT
Go to the T1 cross-connections screen:
- select the NT,
- access the configuration of the NT ports,
- go to the Ports Configuration screen,
.
select structured or unstructured,
.
validate by clicking on «Apply».
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
4.12.3.3
4.12.3.5
III Cross-connection
of time slots of
selected ports
In the T1 cross-connections screen:
- two cross-connect modes are available
depending on whether the cross-connection ports
are structured or unstructured.
- validate the cross-connection by creating the T1
cross-connection (following step).
4.12.3.6
IV Creation of a T1
link
In the T1 cross-connections screen:
- click on the cross-connection creation button.
In the Create a cross-connection window:
- assign a designation to the cross-connection if
you want to modify the default designation.
- click on «OK» to create the link.
4.12.5.3
V Unlocking and
activating the
cross-connection
In the T1 cross-connections screen:
- click on the «unlock» button.
4.12.5.5
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned