User's Manual

256/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
278
6.2.14.6– Creating an ISDN Servic.
Order
number
of steps
Designation Comments
Refer to
paragraph
concerned
I Configuration of
TNT port on BS
Go to the ISDN cross-connections screen:
- select the TNT board,
- access the configuration of the TNT board ports,
- go to the ISDN ports Configuration screen:
- select a port from the list,
- configure the port with ISDN:
.
validate by clicking on «Apply»,
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
4.12.2.3
4.12.4.3
II Creation of an
ISDN signaling
Link (for D
channels)
Go to the ISDN cross-connections screen:
- select signaling,
- select one TS of TNT port,
- assign the TS to the signaling TS,
- click on the cross connection creation button.
4.12.4.2
4.12.1.6
III Activation the
cross-connection
In the ISDN cross-connections screen:
- click on the «Unlock» button.
4.12.4.3
IV Configuration of
TNT port on BS
Go to the ISDN cross-connections screen:
- select the TNT board,
- access the configuration of the TNT board ports,
- select a port from the list,
- configure the port with ISDN:
.
validate by clicking on «Apply»,
.
unlock the administrative status of the port,
.
validate by clicking on «Apply».
V Creation of an
ISDN Link (for B
channels)
Go to the E1 cross-connections screen:
- select the NT,
- select the NT ISDN port
- select one opr two TS of TNT port,
Nota: If only one B channel is inlvolved in the ISDN
link, select only one TS if both B channels or
involved, select two TSs.
- assign the TS to the B channel TS,
- click on the «Cross-connection Creation» button.
4.12.4.2
VI Activation of the
ISDN Link
In the E1 cross-connections screen:
- select the ISDN Link
- click on the «Unlock» button.
4.12.4.2
VII Creation of an
ISDN Link over
another ISDN port
- repeat step IV to VI for the following ISDN port, 4.12.4.2