User's Manual

284/346 Issue 01 - April 2001 - Draft 04 3CC12426AAAA TQ BJA 01
302
7.3.5 – Changing the IP address of the equipment
Note: to ensure remote access after any change of IP address, it is necessary to signal the new IP
address assigned to one of the BS interfaces (ATM or Ethernet) and the new IP configuration of
remote managememt Network to the supervisor before making changes.
7.3.6 – Change of channelling
Order
number
of steps
Designation Comments
Refer to
screens or
paragraphs
concerned
I Notifiying the
supervisor of the
change
Inform the supervisor of the IP address change.
II Changing the NE
IP address
On the BS’s Local Networks screen:
- modify the IP address
- validate by clicking on the «Apply» button
- close the application
- wait (a few minutes) for the terminal to configure
4.9.2 –
III Changing the
network address
On the Network Address screen:
- change the network addresses
- validate by clicking on «Apply»
- close the application
- wait (several minutes) for the terminal to be
configured
4.9.3 –
IV Updating the
installation record
Note the new value of the IP and network addres-
ses in the BS installation record.
Appendix 1
–
IF THE ETHERNET IP ADDRESS CHANGES, IT IS IMPOSSIBLE TO CONNECT
THE LOCAL LT TO THE BS.
Order
number
of steps
Designation Comments
Refer to
screens or
paragraphs
concerned
I Suppressing client
services
Suppress the different cross-connections (leased
lines, IP) by refering to the "suppression of
services" section of Operation.
6.2.15.4 –
(LL)
6.2.15.5 –
(IP)