User manual

Error Messages

Page 35-12

Serial Port Conﬁguration Errors

Message Corrective Action

Problem deleting SLP port

xxx, errno=xx

Reboot the system, then use the Boot Line configuration to

force SLIP down at the boot line (refer to Appendix A “The

Boot Line Prompt”).

Can’t modify SLIP if it’s not

up! current mode=xxx

Reconnect the SLIP line; reconfigure using the slipc command.

Problem changing SLIP

remote IP addr to xxx

Check the remote IP address by using the slipc command at

the UI. Refer to Chapter 6, “Configuring Management Processor

Modules.”

Couldn’t setup SLIP port slxxx

on xxx

Reboot the switch.

Module Connection Errors

Message Corrective Action

interrupt: Link Error Monitor

ALERT on

xxx/xxx PHY-xxx

If this message shows up once or twice, it probably means that

someone is plugging a new cable in slot/port xxx/xxx, physical

connector xxx. If it displays more frequently, then there is

probably a bad CDDI or FFDI connection on slot/port xxx/xxx,

physical connector xxx, caused by either dirty connectors or

bad cabling. Try cleaning the connections or replacing the

cabling.