User manual

Displaying Basic System Information
Page 9-6
Displaying Basic System Information
To display basic information on the switch, enter
info
at the system prompt. The following display is a typical example.
System Make: Alcatel OmniSwitch
System Type: 5-slot OmniSwitch
Description: DESCRIPTION NOT SET.
Backplane: 9 SLOT Bus Speed: 1200 XFRAME
Physical changes to the system since power-up or reset: 2
Logical changes to the system since power-up or reset: 0
Number of Resets to this system: 8
The attached MPM, slot 1, is the Primary
Automatic configuration synchronization is enabled
System base MAC Address: 00:20:da:04:21:f0
Number of Free Slots: 0
Action on Cold Start: Load & go
Action on Reset: Restart
VBus Mode : Mode 1
Script File: /flash/mpx.cmd
Boot File: /flash/mpx.img
Ni Image Suffix: img
The fields displayed by the info command are described below.
System Make. The description of the specific type of chassis or device.
System Type. The OmniSwitch type.
Description. A description of the chassis and product. This field is set by the syscfg command,
which is described in Configuring System Information on page 9-23.
Backplane. The style of backplane used in this chassis.
Bus Speed. The speed of backplane, in Mbs, used in this chassis.
Physical Changes to the system since power-up or reset. The number of physical changes that has
occurred since the last reset or power-on.
Logical Changes to the system since power-up or reset. The number of logical changes that has
occurred since the last reset or power-on.