User manual

Displaying Basic System Information
Page 9-7
No. of Resets to the System. The number of times this switch has been reset since the last cold
start.
♦ Note ♦
The
info command will also display the number of
MPXs, their location in chassis, and which one is the
primary and which one is the secondary. In addition, it
also displays whether automatic configuration synchro-
nization is enabled. See Chapter 6, “Configuring
Management Processor Modules,” for more information
on redundant MPXs and automatic configuration
synchronization.
System Base MAC Address. The base MAC address for the primary MPX in chassis.
Number of Free Slots. The number of slots not occupied by a module.
Action on Cold Start. The action taken when you switch the power on.
Action on Reset. The action taken when you reboot.
Script File. The name of the command file (mpx.cmd is the default) containing user-config-
urable commands.
Boot File. The boot file (mpx.img is the default) used by the switch when it boots up or
reboots.
Ni Image Suffix. The name of the file extension (img is the default) indicating that the file is an
executable binary file. See Chapter 6, “Configuring Management Processor Modules,” to
change this suffix.