User manual

Viewing Port Errors
Page 19-55
Viewing Port Errors
The ve command displays port error statistics for ports in the switch. Entering
ve
displays error statistics for all virtual ports in the switch. You can also display errors statistics
for only ports in a specific Group by specifying the Group ID after the ve command. For
example, to view errors only for ports in Group 6, you would enter
ve 6
You can also display error statistics for a specific port by entering the slot and port number
after the ve command. For example, to view errors only for Port 1 on the module in Slot 4,
you would enter
ve 4/1
The same type of information is displayed for a single Group or port as is displayed for all
ports in a switch. The following screen shows a sample from the ve command when speci-
fied without any Group or port parameters.
Virtual Interface Error Information- For All Interfaces
Slot/ Service/ Buffer Discards Error Discards
Group Intf Instance In Out In Out
===== === =========== =========== =========== ============ =============
2 All Rtr/ 1
3 All Rtr/ 2
1 All Rtr/ 1
1 3/1 Tnk/ 1 0 0 0 0
1 4/1 Brg/ 1 0 0 0 0
1 4/2 Brg/ 1 0 0 0 0
1 4/3 Brg/ 1 0 0 0 0
1 4/4 Brg/ 1 0 0 0 0
1 4/5 Brg/ 1 0 0 0 0
1 4/6 Brg/ 1 0 0 0 0
1 4/7 Brg/ 1 0 0 0 0
1 4/8 Brg/ 1 0 0 0 0
1 5/1 Brg/ 1 0 0 0 0
Group, Slot/Intf.
These columns are described for the vi command on page 19-50.
Service/Instance. The Service Type (Service) and Instance (Instance) of this Service Type in the
switch. Service Type values are as follows:
•
Rtr Virtual router port
•
Brg Virtual bridge port
•
Tnk Virtual trunk port (used for WAN)
•
T10 802.10 FDDI service port
•
FRT Frame Relay trunk port
•
Lne LAN Emulation service port
•
Vlc VLAN clusters (X-LANE) service port
•
CIP Classical IP service port