User manual

Defining and Configuring AutoTracker Policies
Page 20-19
Protocol Specified by Ether-Type
a. To specify a protocol by Ethernet type, enter
5 at the Select Protocol: menu. The follow-
ing prompt displays:
Enter the Ether-type value in hex:
b. Enter the desired Ethernet type in hex. You must enter two bytes of data. For exam-
ple, enter 0800 to specify IP or enter 0806 to specify ARP. All devices that use the
specified Ethernet type will be members of the mobile group or AutoTracker VLAN.
c. Go on to Step 8 below.
Protocol Specified by DSAP and SSAP
a. To specify a protocol by
SAP (service access protocol) header, enter 6 at the Select
Protocol:
menu. The following prompt displays:
Enter the DSAP value in hex:
b. Enter the destination service access protocol (DSAP) value in hex and press <Enter>.
The following prompt displays:
Enter the SSAP value in hex:
c. Enter the source service access protocol (SSAP) value in hex. Each entry must consist
of one byte of data. All devices that use the specified source and destination SAP types
will be members of the mobile group or AutoTracker VLAN.
d. Go on to Step 8 below.
Protocol Specified by SNAP
a. To specify a protocol by
SNAP (sub-network access protocol) type, enter 7 at the Select
Protocol:
menu. The following prompt displays:
Enter the SNAP value in hex
b. Enter the desired SNAP value in hex. You must enter five bytes of data. For example,
enter 0000008137 to specify IPX SNAP or enter 00000080F3 to specify AppleTalk ARP
SNAP. All devices that use the specified SNAP type will be members of the mobile
group or AutoTracker VLAN.
c. Go on to Step 8 below.
8. The following prompt displays:
Configure more rules for this vlan (y/n):
You can set up more devices for this binding policy group. Enter a Y here if you want to
set up more devices. If you enter
Y, you will be prompted for the next rule that you want
to set up. Follow the directions in the appropriate section to configure that rule.
If you enter
N, you will receive a message, similar to the one below, indicating that the
VLAN was set up.
VLAN 2:1 created successfully
You are done setting up rules for this mobile group or AutoTracker VLAN.