User manual

Configuring IP RIP Filters
Page 25-36
Deleting IP RIP Filters
Follow the steps below to delete an existing IP RIP Output or Input filter.
1. Enter
ipfilter.
A screen similar to the following displays:
Selecting global IP filter:
Add or delete entry {add(a), delete(d)} (a) :
Enter d to select to delete a filter.
2. A screen similar to the following displays:
Displaying all filters:
GP:VL (s/p/vc)
# Type Network Mask Md (Peer ID)
--- -------------- ------------------ ---------------- ------ -----------------------
1 RIP OUT 99.0.0.0 255.0.0.0 A global
2 RIP IN 99.0.0.0 255.0.0.0 B 2:1
Entry number to delete? (default: none) :
This screen contains a list of the existing IP RIP filters. The fields on this screen are
described in the next section (see Displaying IP RIP Filters on page 25-37).
3. Enter the index number of the filter that you want to delete. If you decide at this point
that you want to abort out of the deletion process, simply press
Enter to accept the default
of “none”.
4. A message will confirm the deletion of the filter:
ipfilter successfully deleted