User manual

Resetting Statistics Counters
Page 29-54
Resetting Statistics Counters
You can reset the statistics counters for a single WSX board, a WSX port, or a specific DLCI.
The statistics that are cleared on those that are displayed through the frstatus commands. The
frclear command is used to reset statistics.
Resetting Statistics for a WSX Board
To reset statistics on a single WSX board, enter the frclear command along with the slot
number for the WSX board, as follows:
frclear <slot>
where <slot> is the slot number where the WSX board is installed. For example, if you wanted
to clear statistics for the board in slot 4, you would enter:
frclear 4
or
frc 4
Resetting Statistics for a WSX Port
To reset statistics on a single WSX port, enter the frclear command along with the slot number
for the WSX board and the port number as follows:
frclear <slot>/<port>
where <slot> is the slot number where the WSX board is installed and <port> is the port
number on the WSX board. For example, if you wanted to reset statistics for Port 1 on the
WSX module in Slot 4, you would enter:
frclear4/1
or
frc 4/1
Resetting Statistics for a Virtual Circuit (DLCI)
To reset statistics on a single virtual circuit, you enter the frclear command along with the slot
number for the WSX board, the port number, and DLCI number for the virtual circuit on which
you want to reset statistics, as follows:
frclear <slot>/<port>/<DLCI>
where <slot> is the slot number where the WSX board is installed, <port> is the port number
on the WSX board, and <DLCI> is the virtual circuit identifier. For example, if you wanted to
reset statistics for the board in slot 4, port 1,
DLCI 32, you would enter:
frclear 4/1/32
or
frc 4/1/32