User's Manual
Table Of Contents
- Internal-Antenna OmniAccess AP Quick Installation Guide
3/16/04 Step 3: Preparing Mounting Locations
90-100831-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 11
Figure - Factory-Orderable Mounting Brackets
• If necessary, drill holes for the various cables where they can be mostly hidden from casual
view. When you are mounting the OmniAccess AP using an optional separately-orderable
projection-mount L-bracket (the one with two long legs), the cables can be routed through the
5/8-inch (15.9 mm) holes in the bracket.
• Route the CAT-5, optional power supply, optional external antenna cable(s), and optional
Kensington MicroSaver Security cables to where they can plug into the OmniAccess AP. Make
sure to leave about 6 inches (15 cm) of slack in the cables for future modifications.
• Attach the brackets to the wall or ceiling, or install screws for ceiling-mount base:
- Where you are going to use the projection-mount or flush-mount bracket, use
customer-supplied sheet metal, drywall, or other screws to attach the bracket to the
ceiling or wall.
- Where you are going to use the ceiling-mount base, install customer-supplied sheet
metal, drywall, or other screws with 1/4 inch (6.35 mm) or smaller heads protruding
from the ceiling about 0.1 inch (2.5 mm).
You are now ready to install the OmniAccess APs. Continue with Step 4: Mounting the OmniAccess APs
.