User's Manual

3/16/04 Step 4: Mounting the OmniAccess APs
90-100831-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 13
• Attach the ceiling-mount base to the bottom of the OmniAccess AP using the factory-supplied
machine screws and washers.
• Position the ceiling-mount base so its keyhole slots are partly on the drywall, sheet metal, or
other screw heads installed in Step 3: Preparing Mounting Locations
.
Note: If the screws do not securely hold the ceiling-mount base, remove the OmniAccess AP
and adjust the screws until they hold the ceiling-mount base securely.
• Attach the cables to the sides of the OmniAccess AP.
Note: When the OmniAccess AP is powered up and is associated with an Alcatel OmniAccess
Wireless Switch or Appliance (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/
802.11a LEDs lit), the OmniAccess AP is broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within
8 inches (20 cm) of the OmniAccess AP to comply with FCC RF radiation exposure guidelines.
• Slide the ceiling-mount base onto the drywall, sheet metal, or other screw heads until it snugs
into place.
You have installed the OmniAccess AP. Repeat Step 4: Mounting the OmniAccess APs
for each Omni-
Access AP location, and then continue with Step 5: Returning MAC Information
.
Ceiling-Mount ClipsCeiling-Mount Clips
When you are mounting the OmniAccess AP on the extruded aluminium rails of a hanging ceiling, use
the ceiling-mount clips to mount the OmniAccess AP as shown in the following figure and as described
below: