User's Manual

3/16/04 Step 4: Mounting the OmniAccess APs
90-100831-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 18
Figure - Assembling the OmniAccess AP to the Flush-Mount Bracket
• Attach the cables to the sides of the OmniAccess AP.
Note: Make sure the cables are routed away from the OmniAccess AP antennas.
Note: When the OmniAccess AP is powered up and is associated with an Alcatel OmniAccess
Wireless Switch or Appliance (Green/Power and Yellow/802.11b/g and/or Yellow or Amber/
802.11a LEDs lit), the OmniAccess AP begins broadcasting its beacon signal(s). When this
happens, complete the installation as quickly as possible to remove yourself from within
8 inches (20 cm) of the OmniAccess AP to comply with FCC RF radiation exposure guidelines.
You have installed the OmniAccess AP. Repeat Step 4: Mounting the OmniAccess APs
for each Omni-
Access AP location, and then continue with Step 5: Returning MAC Information
.