User's Manual

3/16/04 FCC Statements for OmniAccess APs
90-100831-000 Rev 5Alcatel OmniAccess Wireless Access Point Quick Installation Guide 21
About Physical SecurityAbout Physical Security
Regardless of mounting, the OmniAccess AP can be secured with a Kensington MicroSaver Security
Cable. If required, use any MicroSaver Security Cable to attach either side of your OmniAccess AP to a
solid beam, pipe, or support.
FCC Statements for OmniAccess APsFCC Statements for OmniAccess APs
This section includes the following FCC statements for the OmniAccess AP:
• Class A Statement
• RF Radiation Hazard Warning
• Non-Modification Statement
• Deployment Statement
Class A StatementClass A Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
RF Radiation Hazard WarningRF Radiation Hazard Warning
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location
such that the antenna of the device will be greater than 20 cm (8 in.) from all persons. Using higher
gain antennas and types of antennas not covered under the FCC certification of this product is not
allowed.
Installers of the radio and end users of the Alcatel OmniAccess Wireless Enterprise Platform must
adhere to the installation instructions provided in this manual.
Non-Modification StatementNon -Mod ificat ion St atem ent
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unautho-
rized antennas, modifications, or attachments could damage the badge and could violate FCC
regulations and void the user’s authority to operate the equipment.
Note: Refer to the Alcatel OmniAccess Wireless System Release Notes for 802.11a external
antenna information. Contact Alcatel Internetworking, Inc. for a list of FCC-approved 802.11a
and 802.11b/g external antennas.
Deployment StatementDeployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.