User's Manual
Table Of Contents
- 7368 ISAM ONT G-120W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-120W-F unit data sheet
- 5.1 G-120W-F part numbers and identification
- 5.2 G-120W-F general description
- 5.3 G-120W-F software and installation feature support
- 5.4 G-120W-F interfaces and interface capacity
- 5.5 G-120W-F LEDs
- 5.6 G-120W-F detailed specifications
- 5.7 G-120W-F GEM ports and T-CONTs
- 5.8 G-120W-F performance monitoring statistics
- 5.9 G-120W-F functional blocks
- 5.10 G-120W-F standards compliance
- 5.11 G-120W-F special considerations
- 6 Install a G-120W-F indoor ONT
- 7 Replace a G-120W-F indoor ONT
- 8 Configure a G-120W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-120W-F Product Guide Configure a G-120W-F indoor ONT
Issue: 01 3FE-46922-AAAA-TCZZA 139
2 Enter your username and password in the Log in window, as shown in Figure 68.
The default username is adminadmin. The default password is ALC#FGU.
Figure 68 Web login window
3 Click Login.
4 STOP. This procedure is complete.
8.3.2 Device and connection status
G-120W-F ONTs support the retrieval of a variety of device information, as well as
the optics module status.
Caution — Pressing the Reset button for less than 10 seconds reboots
the ONT; pressing the Reset button for 10 seconds resets the ONT to the
factory defaults, except for the LOID and SLID.
Note — If you forget the current username and password, press the
reset button for 10 s and the default values for the username and
password will be recovered at startup.
R05.06.01 | June 2017 | Edition 01