User's Manual

7368 ISAM ONT G-120W-F Product Guide G-120W-F unit data sheet
Issue: 01 3FE-46922-AAAA-TCZZA 53
Figure 15 G-120W-F indoor ONT physical connections
Table 5 describes the physical connections for G-120W-F indoor ONTs.
Table 5 G-120W-F indoor ONT physical connections
Note
(1)
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the power
connector.
Connection
(1)
Description
GPON
(Fiber optic port)
This connection is provided through an SC/APC fiber optic connector.
TEL1
(RJ-11 POTS port)
This connection is provided through an RJ-11 port. The POTS port supports voice
services.
LAN1 and LAN2
(RJ-45 Ethernet ports)
This connection is provided through Ethernet RJ-45 connectors. One 10/100/1000
GE and one 10/100 FE Base-T Ethernet interface are supported.The Ethernet
ports can support both data and in-band video services on all four interfaces.
POWER
(Power input)
This connection is provided through the power connector. A power cable fitted with
a barrel connector is used to make the connection.
RESET Pressing the Reset button for less than 10 seconds reboots the ONT; pressing the
Reset button for 10 seconds resets the ONT to the factory defaults, except for the
LOID and SLID.
WLAN
(Wireless On/Off button)
Wi-Fi service is compliant with IEEE 802.11 standards and is enabled or disabled
using the WLAN button.
WPS
(Wi-Fi security button)
The Wi-Fi Protected Setup (WPS) button enables and disables WLAN data
encryption.
LED
(LED indicator button)
This button turns all LED indicators on or off.
ON/OFF This button turns the ONT on or off.
TELGPON LAN2 LAN1 POWER RESET WLAN WPS LED ON/OFF
Fiber
connection
POTS
port
Ethernet
Ports (2)
Power
input
Reset
ONT
Antenna Antenna
Wireless
on/off
WPS
on/off
LEDs
on/off
ONT
on/off
26048
R05.06.01 | June 2017 | Edition 01