User's Manual

2 — Install a G-241W-A indoor ONT
2-8 Alcatel-Lucent 7368 ISAM ONT
Edition 01
I-240W-S I-241W-S I-241W-U Product Guide
Figure 2-5 Molex 8-pin connector
10 Power up the ONT unit by using the on/off power switch; see Figure 2-3 for the
location of the power switch.
11 If used, enable the Wi-Fi service, as described in Configure a G-241W-A indoor
ONT.
12 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368
Hardware and Cabling Installation Guide.
13 Activate and test the services; see the 7368 Hardware and Cabling Installation
Guide.
14 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management,
and Troubleshooting Guide for more information.
15 If necessary, reset the ONT.
i Access the Rest button. See Figure 2-3 for the location of the Reset button.
ii Insert the end of a straightened paper clip or other narrow object into the
hole in the Reset button to reset the ONT.
16 STOP. This procedure is complete.
Note — Observe the following:
• Only Pins 1, 2, and 7 in the Molex connector pin arrangement shown
in Figure 2-5 are used with G-241W-A indoor ONTs.
Pin 2 Pin 8
Pin 1 Pin 3 Pin 7
20179