User's Manual

3 — Replace a G-241W-A indoor ONT
Alcatel-Lucent 7368 ISAM ONT 3-7
Edition 01
I-240W-S I-241W-S I-241W-U Product Guide
13 Connect the power cable with an 8-pin Molex connector to the ONT unit; see
Figure 3-3 for the Molex pin alignment.
Figure 3-3 Molex 8-pin connector
14 Power up the unit by using the on/off power switch; see Figure 3-1 for the location
of the power switch.
15 If used, enable the Wi-Fi service, as described in Configure a G-241W-A indoor ONT
16 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management,
and Troubleshooting Guide for more information.
17 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368
Hardware and Cabling Installation Guide.
18 Activate and test the services; see the 7368 Hardware and Cabling Installation
Guide.
19 If necessary, reset the ONT.
i Access the Rest button. See Figure 3-1 for the location of the Reset button.
ii Insert the end of a straightened paper clip or other narrow object into the
hole in the Reset button to reset the ONT.
20 STOP. This procedure is complete.
Warning — To avoid the possibility of damage to the pins on the power
cable connector, carefully align the pins on the connector on the cable
with the pin holes in the power connector on the ONT before making the
connection.
Note — Observe the following:
• Only Pins 1, 2, and 7 in the Molex connector arrangement shown in
Figure 3-3 are used with the G-241W-A indoor ONT.
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more details.
Pin 2 Pin 8
Pin 1 Pin 3 Pin 7
20179