User's Manual

Install the Unistruts as follows:
...................................................................................................................................................................................................
1
Determine the layout of the struts that will support the cabinet.
...................................................................................................................................................................................................
2
Place the top strut on the wall and make sure that the strut is level. Use the holes at the
ends of the strut as a template to mark the positions of the holes to be drilled in the wall.
...................................................................................................................................................................................................
3
Place the bottom strut against the wall [350 mm (13.8 inches) for 4x40W and 800 MHz
RRHs] [515 mm for 4x45W 65 MHz RRH], measured center to center, from the top strut.
Use the holes in the strut as a template to mark the positions of the holes to be drilled in
the wall. See the figure below.
...................................................................................................................................................................................................
4
Drill holes in the wall at the marked positions using an appropriate concrete drill bit for
selected anchor.
...................................................................................................................................................................................................
5
To install the top strut, place the top strut against the wall. Drive the anchor bolts into the
holes of the strut until nut and washer are flush with the strut.
...................................................................................................................................................................................................
6
Tighten the nut to proper torque requirement.
...................................................................................................................................................................................................
7
Repeat Steps 5 and 6 to install the bottom strut.
Basic site preparation requirements and footprints for
RRHs
Site requirements for RRHs
Site requirements for wall mount installations
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
6-14
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
9927 Dist BTS Outdoor
401-703-516
Issue 1 March 2012
E ND OF STEPS
...................................................................................................................................................................................................